Product Type Features

• • Power Component Options :Channels & Clips

  • Coating Style :Inline

Adhesive Coating :With

• Power Cable Wrap Product Type :Sleeve

• Wall Style (Excluding Adhesive) :Single

• Installation Technology :Heat Shrink

Body Features

• Primary Product Material :Crosslinked Polyolefin

• Primary Product Color :Black

• Flexibility :Semi-Rigid

• Shrink Ratio :>3:1

Dimensions

• Compatible Cable Diameter (Max) :86 mm [ 3.385 in ]

• Compatible Cable Diameter (Min) :33 mm [ 1.299 in ]

• Wall Thickness :Medium

• Recovered Wall Thickness (Max) (mm):1.8

• Expanded Inside Diameter (Min) :144 mm [ 5.669 in ]

• Recovered Inside Diameter (Max) :28 mm [ 1.1 in ]

• Product Length :1500 mm [ 59.055 in ]

Usage Conditions

• Environmental Resistance :Contaminated Water | Moisture | Rain | Salt Water | Weathering

• Fluid Resistance Type :Hydrocarbons | Transformer Oil

• Flammability Performance :Non-Flame-Retardant

Operation/Application

• Thermal Resistance :Applicable for High Temperatures | Applicable for Low Temperatures

• Marine-Offshore-Shipbuilding Certified :Yes

• Power Component Application Type :Underground

• UV-Stabilized :Yes

• Mechanical Resistance :Against Mechanical Impact or Damage

General Instructions
Use a propane (preferred) or butane gas torch.
Adjust the torch to obtain a soft blue fl ame with a yellow tip.
Pencil-like blue fl ames should be avoided.
To repair the damaged metal sheath of a served cable,
remove the serving, armour and bedding so that the
wraparound can be installed directly onto the metal sheath.
Cable inspection (before installation):
Carefully remove the cable jacket in the area where the cable
is damaged. Control the cable construction beneath the
oversheath for tracks of further damage.
If there is no damage, replace the oversheath. If there is a
damage an appropriate repair must be carried out.
The wrap-around should extend for at least 50 mm at each
end beyond the area to be protected.
Installation steps
1. Clean, degrease (use degreasing solvent) and abrade the
oversheath, where it comes into contact with the wraparound.
2. Remove the foil from the adhesive side of the wraparound.
3. Position the wraparound centrally around the area of damage.
4. Slide the steel channel(s) onto the rail and if more than one
channel is required, fi t the clip over the channel ends where
they come together (the use of pulling tool IT-1000-014 is
recommended for channels longer than 500 mm).
5. Start shrinking in the centre opposite the channel
working round towards the ends.
6. Continue heating the channel area until adhesive fl ows out on
both ends of the channel.
7. Installation completed. Allow the wraparound to cool
before applying any mechanical strain.

About this item

• Shrink ratio 4:1
• Operating temperature range: -30°C to +100°C.
• High mechanical strength and impact resistance
• Halogen-free material content, corrosion-free and non-toxic smoke in case of fire
• All-round sheathing for repairing damaged cable sheaths and wrapping low voltage joints.

Product description